|
Another Shot of the Socket Bracket
|
Poor thing is nasty. It's two pieces. One is bolted to the top of the reflector from the inside and is stationary. The second piece is what the socket attaches to and is supposed to be adjustable via two screws on either side where the reflector hole it. It's all rusted to one piece now, screws included. What's supposed to happen is you loosen the two screws, pinch the sides together, and move the socket to the next set of notches and retighten. Similar to the original M-250A/M-400A socket bracket if you're familiar with it.
|
|
If worse comes to worst I could bolt a flat piece of sheet metal over the opening and just mount the socket directly to that (non-adjustable). I'd have to check but the lamp should be roughly centered (an ED23.5). Since even if I somehow get new brackets fabricated, the gaping hole will be a problem.